Framed Glass Assembly Guide - Adapters







- Please note cover plates may need to be temporarily secured to posts with tape to allow easy marking out / fixing of anchors
Handrail components can now be bonded with supplied adhesive to secure handrail (See adhesive details at base of page)
Wall connectors are secured with adhesive and locator screw
Glass panels can now be secured in clamps using rubber inlays- if holes are in glass then the safety pin should also be used - Safety pins must be used for side fixed installations
Glass clamps are split using Hex Key, the glass clamps may need slight rotation / adjustment on posts to ensure correct alignment
Video below shows glass clamp assembly - please note baluster posts already have threaded hole - no drilling is required - this video is for guidance only
Adhesive Instructions
Clean Interior Surface of tube / exterior surface of fitting using cleaner and dry cloth
Apply a line of adhesive to interior surface of tube / exterior surface of fitting
Bring together with a twisting motion to spread adhesive evenly
Remove any excess adhesive with a clean dry cloth - wait 72 hours until adhesive has fully hardened
Cleaning and Maintenance
Stainless steel is not completely maintenance free, but it’s easy to maintain.
Simply wash the stainless steel periodically with soapy water to keep the original appearance, the glass panels can be added to your window cleaners round, or simply clean with readily available glass cleaning products